Revise paste Temperature Monitor rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Temperature Monitor
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-06 21:14:09

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Turns on the built-in LED when the temperature */
	/* exceeds 75 degrees Fahrenheit. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <DS18B20.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t accurateTemperature_DS18B20_DQ_PIN_D2 = 2;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
DS18B20 ds(accurateTemperature_DS18B20_DQ_PIN_D2);

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(LED_BUILTIN, OUTPUT);

// Turns on the built-in LED when the temperature exceeds 75 degrees Fahrenheit
}

void loop(void)
{
  // put your main code here, to run repeatedly:

// Read temperature from DS18B20 sensor
  float temperature = ds.getTempC();

// Display temperature on Serial Monitor
  Serial.print("Temperature: ");
  Serial.print(temperature);
  Serial.println(" °C");

// Check if temperature exceeds 75 degrees Fahrenheit
  if (temperature > 75) {
    digitalWrite(LED_BUILTIN, HIGH); // Turn on built-in LED
  } else {
    digitalWrite(LED_BUILTIN, LOW); // Turn off built-in LED
  }

delay(1000); // Wait for 1 second
}