Revise paste Button LED rev_04

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Button LED
	- Source Code NOT compiled for: Arduino Nano
	- Source Code created on: 2024-04-25 11:48:52

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Ensure LED diode turns on for 50ms after pressing */
	/* the Button. It should turn off after 50ms, even if */
	/* the button is still pressed. Allow reactivation */
	/* only after a 2s delay. Button is connected to pin */
	/* 6, diode is connected to pin 7. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

#include <Arduino.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t Button_PIN = 6;

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t LED_PIN = 7;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
bool LED_state = LOW;
unsigned long lastDeactivationTime = 0;

void setup(void)
{
	// put your setup code here, to run once:
	pinMode(Button_PIN, INPUT_PULLUP);
	pinMode(LED_PIN, OUTPUT);
}

void loop(void)
{
	// put your main code here, to run repeatedly:
	if (digitalRead(Button_PIN) == LOW) {
		// Button is pressed
		digitalWrite(LED_PIN, HIGH); // Turn on LED
		delay(50); // Keep LED on for 50ms
		digitalWrite(LED_PIN, LOW); // Turn off LED
		lastDeactivationTime = millis(); // Record the time of deactivation
	}

// Check if reactivation is allowed after 2s delay
	if (millis() - lastDeactivationTime >= 2000) {
		updateOutputs(); // Refresh output data
	}
}

void updateOutputs()
{
	// Update LED state based on the condition
	if (digitalRead(Button_PIN) == HIGH) {
		LED_state = LOW; // Reset LED state
	}
	digitalWrite(LED_PIN, LED_state);
}

/* END CODE */