Revise paste "Temperature Tracker" rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: "Temperature Tracker"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2024-03-05 22:40:56

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* I integrate the JDY-31 Bluetooth module with your */
	/* Arduino Uno R3, along with a thermistor */
	/* temperature sensor write a code that reads the */
	/* resistnace from the thermistor, converts it to */
	/* temprature using this equation y = */
	/* 25.76e^-0.039x,where y is the T */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <SoftwareSerial.h>
#include <math.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF Software Serial *****/
const uint8_t JDY31_HC05_mySerial_PIN_SERIAL_TX_A0 = A0;
const uint8_t JDY31_HC05_mySerial_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial JDY31_HC05_mySerial(JDY31_HC05_mySerial_PIN_SERIAL_RX_A1, JDY31_HC05_mySerial_PIN_SERIAL_TX_A0);

// Define the pins for the thermistor
const int thermistorPin = A2;

void setup(void)
{
  // put your setup code here, to run once:
  JDY31_HC05_mySerial.begin(9600);
  Serial.begin(9600); // Initialize the Serial Monitor
}

void loop(void)
{
  // put your main code here, to run repeatedly:

// Read the resistance from the thermistor
  int thermistorValue = analogRead(thermistorPin);

// Convert the resistance to temperature using the equation y = 25.76e^-0.039x
  float temperature = 25.76 * exp(-0.039 * thermistorValue);

// Print the temperature to the Serial Monitor
  Serial.print("Temperature: ");
  Serial.print(temperature);
  Serial.println(" degrees Celsius");

// Delay for 1 second
  delay(1000);
}