Revise paste Analog Communication rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Analog Communication
	- Source Code NOT compiled for: Arduino Uno
	- Source Code created on: 2024-05-20 09:21:25

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* I am using Arduino uno for a project   The project */
	/* idea is I'm going to send an audio signal through */
	/* the Arduino uno and take output through it.  The */
	/* function is whatever the signal audio signal is */
	/* given the output must me in the decibel which I */
	/* will */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

#include <Arduino.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF ANALOG INPUT PINS *****/
const uint8_t potentiometer_Potentiometer_Vout_PIN_A0 = A0;
const uint8_t potentiometer_Potentiometer_Vout_PIN_A1 = A1;

void setup(void)
{
	// put your setup code here, to run once:

pinMode(potentiometer_Potentiometer_Vout_PIN_A0, INPUT);
	pinMode(potentiometer_Potentiometer_Vout_PIN_A1, INPUT);

// Initialize serial communication
	Serial.begin(9600);
}

void loop(void)
{
	// put your main code here, to run repeatedly:

// Read analog input values
	int sensorValue_A0 = analogRead(potentiometer_Potentiometer_Vout_PIN_A0);
	int sensorValue_A1 = analogRead(potentiometer_Potentiometer_Vout_PIN_A1);

// Print the sensor values to the serial monitor
	Serial.print("Sensor Value A0: ");
	Serial.println(sensorValue_A0);
	Serial.print("Sensor Value A1: ");
	Serial.println(sensorValue_A1);

// Delay for readability
	delay(1000);
}

/* END CODE */