Revise paste Button Control rev_02

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Button Control
	- Source Code NOT compiled for: Arduino Nano
	- Source Code created on: 2024-04-25 11:41:27

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Ensure LED diode turns on for 50ms after pressing */
	/* the EasyButton. It should turn off after 50ms, */
	/* even if the button is still pressed. Allow */
	/* reactivation only after a 2s delay. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

#include <EasyButton.h>

EasyButton button(Przycisk_PushButton_PIN_D2); // Initialize EasyButton with pin 2

unsigned long lastDebounceTime = 0;
unsigned long debounceDelay = 50;
unsigned long reactivateDelay = 2000;
bool ledState = LOW;
bool buttonState = LOW;

void setup(void)
{
    // put your setup code here, to run once:
    pinMode(Przycisk_PushButton_PIN_D2, INPUT_PULLUP);
    pinMode(Zawor_LED_PIN_D3, OUTPUT);

button.begin(); // Initialize EasyButton

}

void loop(void)
{
    // put your main code here, to run repeatedly:
    button.read(); // Read the state of the button

if (button.isPressed()) {
        if (millis() - lastDebounceTime > debounceDelay) {
            lastDebounceTime = millis();
            ledState = HIGH;
            digitalWrite(Zawor_LED_PIN_D3, ledState);
            delay(50);
            ledState = LOW;
            digitalWrite(Zawor_LED_PIN_D3, ledState);
            delay(reactivateDelay);
        }
    }
}

/* END CODE */