Revise paste Irsensor rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Irsensor
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-06 13:39:31
	- Source Code generated by: Vedant

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Create an animation of 3d cude on the display */
/****** SYSTEM REQUIREMENT 2 *****/
	/* Create an animation of 3d cude on the display */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Wire.h>
#include <Adafruit_SSD1306.h>
#include <U8g2_for_Adafruit_GFX.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF I2C PINS *****/
const uint8_t Irsensor_SSD1306OledDisplay_I2C_PIN_SDA = A4;
const uint8_t Irsensor_SSD1306OledDisplay_I2C_PIN_SCL = A5;
const uint8_t Irsensor_SSD1306OledDisplay_I2C_SLAVE_ADDRESS = 0x3C;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Adafruit_SSD1306 display(Irsensor_SSD1306OledDisplay_I2C_SLAVE_ADDRESS);
U8G2_FOR_ADAFRUIT_GFX u8g2_for_adafruit_gfx;

void setup(void)
{
  // put your setup code here, to run once:
  display.begin(SSD1306_SWITCHCAPVCC, Irsensor_SSD1306OledDisplay_I2C_PIN_SDA, Irsensor_SSD1306OledDisplay_I2C_PIN_SCL);
  u8g2_for_adafruit_gfx.begin(display);

display.display();
  delay(2000);
  display.clearDisplay();
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  
  // Animation of a 3D cube
  // System Requirement 1
  // TODO: Add code for 3D cube animation
  
  // Animation of a 3D cube
  // System Requirement 2
  // TODO: Add code for 3D cube animation
}