Revise paste Very basic IR Remote Receiver to Serial

//Install library
//http://pastebin.com/kNMMxkkk
//For computer side of things http://pastebin.com/PXCbLKNj
//------------------------------------------------------------------------------
// Include the IRremote library header
//
#include <IRremote.h>

//------------------------------------------------------------------------------
// Tell IRremote which Arduino pin is connected to the IR Receiver (TSOP4838)
//
int recvPin = 11;
IRrecv irrecv(recvPin);

//+=============================================================================
// Configure the Arduino
//
void  setup ( )
{
  Serial.begin(9600);   // Status message will be sent to PC at 9600 baud
  irrecv.enableIRIn();  // Start the receiver
}

void  dumpCode (decode_results *results)
{

// All protocols have data
    Serial.print(results->value, HEX);
    Serial.print("\n");
  
}

//+=============================================================================
// The repeating section of the code
//
void  loop ( )
{
  decode_results  results;        // Somewhere to store the results

if (irrecv.decode(&results)) {  // Grab an IR code
    
    dumpCode(&results);           // Output the results as source code
    irrecv.resume();              // Prepare for the next value
  }
}