Revise paste LED Toggle rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: LED Toggle
	- Source Code NOT compiled for: Arduino Uno
	- Source Code created on: 2024-08-24 15:28:35

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* The project shall implement LED control on pin D2, */
	/* requiring continuous monitoring and updating of */
	/* its state using raw data. The setup function must */
	/* configure the pin for output to enable LED */
	/* functionality. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(); // Function prototype for updating outputs

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t led_LED_PIN_D2 = 2; // Pin for LED control

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool led_LED_PIN_D2_rawData = 0; // Initial state of the LED (off)

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float led_LED_PIN_D2_phyData = 0.0; // Placeholder for transformed data

// Instantiate any necessary objects here (if required by libraries)
// Currently, no additional libraries are included that require instantiation

void setup(void)
{
	// Configure pin D2 as an output to enable LED functionality
	pinMode(led_LED_PIN_D2, OUTPUT); // Set pin D2 as an output
}

void loop(void)
{
	// Continuous monitoring and updating of LED state
	led_LED_PIN_D2_rawData = !led_LED_PIN_D2_rawData; // Toggle LED state for demonstration
	updateOutputs(); // Refresh output data based on the raw data
	delay(1000); // Delay for 1 second to observe LED state change
}

void updateOutputs()
{
	// Update LED state based on raw data
	digitalWrite(led_LED_PIN_D2, led_LED_PIN_D2_rawData); // Write the current state to the LED
}

/* END CODE */