Revise paste **Servo Control** rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: **Servo Control**
	- Source Code NOT compiled for: Arduino Uno
	- Source Code created on: 2024-11-12 19:23:38

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* The project aims to develop an Arduino-based */
	/* system that utilizes connected components for */
	/* automated tasks, ensuring efficient resource */
	/* management and seamless integration of libraries */
	/* for enhanced functionality. */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include <Wire.h>   // Include Wire library for I2C communication
#include <SPI.h>    // Include SPI library for SPI communication
#include <Servo.h>  // Include Servo library to control servo motors

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/****** GLOBAL VARIABLES *****/
Servo myServo; // Create a Servo object

void setup(void)
{
    // Initialize I2C communication
    Wire.begin();

// Initialize SPI communication
    SPI.begin();

// Attach the servo to pin 9
    myServo.attach(9);

// Set initial position of the servo
    myServo.write(90); // Move servo to the middle position
}

void loop(void)
{
    // Example of controlling the servo
    for (int pos = 0; pos <= 180; pos += 1) // Sweep from 0 to 180 degrees
    {
        myServo.write(pos); // Move servo to position
        delay(15); // Wait 15 milliseconds for the servo to reach the position
    }
    for (int pos = 180; pos >= 0; pos -= 1) // Sweep from 180 to 0 degrees
    {
        myServo.write(pos); // Move servo to position
        delay(15); // Wait 15 milliseconds for the servo to reach the position
    }
}

/* END CODE */