Revise paste "Digital Potentiometer Setup" rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: "Digital Potentiometer Setup"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2024-03-14 15:21:35

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Write a code in a way to set the wiper position of */
	/* digital potentiometer. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <SPI.h> // Include the SPI library for communication with digital potentiometer

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF ANALOG INPUT PINS *****/
const uint8_t digipot_Potentiometer_Vout_PIN_A0 = A0;

void setup(void)
{
  // Set the SPI communication mode
  SPI.begin();

// Set the digital potentiometer as an output
  pinMode(digipot_Potentiometer_Vout_PIN_A0, OUTPUT);
}

void loop(void)
{
  // Set the wiper position of the digital potentiometer
  // Replace "wiperPosition" with the desired position value (0-255)
  uint8_t wiperPosition = 128; // Example position value
  
  // Send the wiper position data to the digital potentiometer
  digitalWrite(digipot_Potentiometer_Vout_PIN_A0, LOW); // Set the chip select pin low
  SPI.transfer(wiperPosition); // Send the position value over SPI
  digitalWrite(digipot_Potentiometer_Vout_PIN_A0, HIGH); // Set the chip select pin high

// Delay for a certain amount of time before setting the wiper position again
  delay(1000); // Example delay time
}