Revise paste Potentiometer PWM rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Potentiometer PWM
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-28 05:08:01

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Increase or decrease the brightness of LED */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>

/***** DEFINITION OF ANALOG INPUT PINS *****/
const uint8_t Input_Potentiometer_Vout_PIN_A0 = A0;
const uint8_t PWM_Output_PIN = 9;

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(Input_Potentiometer_Vout_PIN_A0, INPUT);
  pinMode(PWM_Output_PIN, OUTPUT);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  // Read the potentiometer value
  int potValue = analogRead(Input_Potentiometer_Vout_PIN_A0);

// Map the potentiometer value to the duty cycle range (0-255)
  uint8_t dutyCycle = map(potValue, 0, 1023, 0, 255);

// Set the duty cycle of the PWM using analogWrite
  analogWrite(PWM_Output_PIN, dutyCycle);

// Delay for stability
  delay(10);
}