Revise paste "Digital Toggle" rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: "Digital Toggle"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2024-01-25 22:39:43

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Falling Ball Viscometer with 2 optical sensors */
	/* connected to plc */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>

/* FUNCTION PROTOTYPES */
void setup(void);
void loop(void);

/* DEFINITION OF DIGITAL OUTPUT PINS */
const uint8_t sensor_led_PIN_D2 = 2; // Assigning pin 2 to sensor_led_PIN_D2
const uint8_t sensor_led2_PIN_D3 = 3; // Assigning pin 3 to sensor_led2_PIN_D3

void setup(void)
{
    // initialize digital pins as output
    pinMode(sensor_led_PIN_D2, OUTPUT);
    pinMode(sensor_led2_PIN_D3, OUTPUT);
}

void loop(void)
{
    // put your main code here, to run repeatedly:

// Toggle the state of sensor_led_PIN_D2
    digitalWrite(sensor_led_PIN_D2, HIGH);
    delay(500);
    digitalWrite(sensor_led_PIN_D2, LOW);
    delay(500);

// Toggle the state of sensor_led2_PIN_D3
    digitalWrite(sensor_led2_PIN_D3, HIGH);
    delay(500);
    digitalWrite(sensor_led2_PIN_D3, LOW);
    delay(500);
}