Revise paste Debounced Button rev_10

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Debounced Button
	- Source Code compiled for: Arduino Opta WiFi
	- Source Code created on: 2025-10-05 15:05:13

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Detect a debounced push-button event on A0 using */
	/* EasyButton; the input uses INPUT_PULLUP, so a */
	/* pressed state is LOW and should trigger the system */
	/* logic. Integrate flash over the air. */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include <EasyButton.h>  // https://github.com/evert-arias/EasyButton
#include <POTA.h>         // https://github.com/pleasedontcode/POTA

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void buttonPressedOTA();

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t button_PushButton_PIN_A0 = A0;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES******/
EasyButton button(button_PushButton_PIN_A0);
POTA ota;

/*
  Callback invoked when the button is pressed.
  Triggers a POTA OTA check/perform.
*/
void buttonPressedOTA()
{
  Serial.println("A0 button pressed - attempting OTA");
  // Attempt OTA update using POTA
  POTAError err = ota.checkAndPerformOTA();
  if (err == POTAError::NO_UPDATE_AVAILABLE)
  {
    Serial.println("OTA: No update available");
  }
  else if (err != POTAError::SUCCESS)
  {
    Serial.print("OTA error: ");
    Serial.println(ota.errorToString(err));
  }
  else
  {
    Serial.println("OTA update started or completed");
  }
}

void setup(void)
{
  Serial.begin(115200);
  Serial.println();
  Serial.println("POTA OTA on A0 button (debounced) example");

// Configure the input with internal pull-up to match system requirement
  pinMode(button_PushButton_PIN_A0, INPUT_PULLUP);

// Initialize the button debouncer
  button.begin();

// Attach press event
  button.onPressed(buttonPressedOTA);
}

void loop(void)
{
  // Update button state (debouncing handled by library)
  button.read();
  // You may add small delay here if desired
}

/* END CODE */