Revise paste Flow Tracker rev_167

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Flow Tracker
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-07 12:26:19

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* read flow meter and print on serial monitor. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <FlowSensor.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t sens_YF_B1_OUT_PIN_D2 = 2;

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t VERDE_LED_PIN_D11 = 11;
const uint8_t ROSSO_LED_PIN_D12 = 12;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
FlowSensor Sensor(YFS201, sens_YF_B1_OUT_PIN_D2);
unsigned long timebefore = 0;
unsigned long reset = 0;

void count()
{
  Sensor.count();
}

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(sens_YF_B1_OUT_PIN_D2, INPUT);
  pinMode(VERDE_LED_PIN_D11, OUTPUT);
  pinMode(ROSSO_LED_PIN_D12, OUTPUT);

Serial.begin(115200);
  Sensor.begin(count);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  if (millis() - timebefore >= 1000)
  {
    Sensor.read();
    Serial.print("Flow rate (L/minute) : ");
    Serial.println(Sensor.getFlowRate_m());
    Serial.print("Volume (L) : ");
    Serial.println(Sensor.getVolume());
    timebefore = millis();
  }

if (millis() - reset >= 60000)
  {
    Sensor.resetVolume();
    reset = millis();
  }
}