Revise paste table rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: table
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-04 07:57:41
	- Source Code generated by: Gaurav

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* when touch sensor is on the turn on led at that */
	/* place there are 20 sensor with different led strip */
	/* connected to it */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t led_LEDRGB_Red_PIN_D2 = 2;
const uint8_t led_LEDRGB_Green_PIN_D3 = 3;
const uint8_t led_LEDRGB_Blue_PIN_D4 = 4;

const uint8_t touchSensor_PIN_A0 = A0;

void setup(void)
{
	// put your setup code here, to run once:

pinMode(led_LEDRGB_Red_PIN_D2, OUTPUT);
	pinMode(led_LEDRGB_Green_PIN_D3, OUTPUT);
	pinMode(led_LEDRGB_Blue_PIN_D4, OUTPUT);
	pinMode(touchSensor_PIN_A0, INPUT);

}

void loop(void)
{
	// put your main code here, to run repeatedly:
	
	// Check if touch sensor is activated
	if (digitalRead(touchSensor_PIN_A0) == HIGH) {
		// Turn on LED strip
		digitalWrite(led_LEDRGB_Red_PIN_D2, HIGH);
		digitalWrite(led_LEDRGB_Green_PIN_D3, HIGH);
		digitalWrite(led_LEDRGB_Blue_PIN_D4, HIGH);
	} else {
		// Turn off LED strip
		digitalWrite(led_LEDRGB_Red_PIN_D2, LOW);
		digitalWrite(led_LEDRGB_Green_PIN_D3, LOW);
		digitalWrite(led_LEDRGB_Blue_PIN_D4, LOW);
	}
}