Revise paste Scanner rev_171

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Scanner
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-11-19 12:14:49
	- Source Code generated by: AlexWind

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Servo.h>
#include "Ultrasonic-distance-sensor-easyC-SOLDERED.h"

/****** SYSTEM REQUIREMENT 1 *****/
/* when something in front ultrasonic sensor senses */
/* it and then the servo motor rotates and moves to */
/* space where no obstacle is present */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t servo_Servomotor_PWMSignal_PIN_D3 = 3;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Servo myservo;
Ultrasonic_Sensor ultrasonicSensor;

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(servo_Servomotor_PWMSignal_PIN_D3, OUTPUT);

// Attach the servo to the pin
  myservo.attach(servo_Servomotor_PWMSignal_PIN_D3);

// Initialize the ultrasonic sensor
  ultrasonicSensor.begin();
}

void loop(void)
{
  // put your main code here, to run repeatedly:

// Read the distance from the ultrasonic sensor
  uint16_t distance = ultrasonicSensor.getDistance();

// Check if an obstacle is detected
  if (distance < 20)
  {
    // Rotate the servo to move to a space where no obstacle is present
    myservo.write(90);
  }
  else
  {
    // Rotate the servo to the initial position
    myservo.write(0);
  }

// Delay for a short period
  delay(100);
}