Revise paste ESC Control rev_04

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: ESC Control
	- Source Code NOT compiled for: Arduino Nano
	- Source Code created on: 2024-10-19 13:55:46

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* code to control two escs connected to specify */
	/* pins, start with calibration and arming for 30s */
	/* then run the motors for 45s with 50% of speed */
	/* after that turn off the motors */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Servo.h>	//https://github.com/arduino-libraries/Servo

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t esc1_PIN_D6		= 6; // Pin for ESC1
const uint8_t esc2_PIN_D9		= 9; // Pin for ESC2

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
uint8_t esc1_PIN_D6_rawData		= 0;
uint8_t esc2_PIN_D9_rawData		= 0;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
// Create Servo objects for each ESC
Servo esc1; // Object for ESC1
Servo esc2; // Object for ESC2

void setup(void)
{
	// Attach the Servo objects to the corresponding pins
	esc1.attach(esc1_PIN_D6); // Attach ESC1 to pin D6
	esc2.attach(esc2_PIN_D9); // Attach ESC2 to pin D9

// Initialize ESCs for calibration and arming
	for (int i = 0; i < 30; i++) { // 30 seconds for calibration
		esc1.write(0); // Send minimum signal to ESC1
		esc2.write(0); // Send minimum signal to ESC2
		delay(1000); // Wait for 1 second
	}

// After calibration, send a signal to arm the ESCs
	esc1.write(90); // Send a neutral signal to ESC1
	esc2.write(90); // Send a neutral signal to ESC2
	delay(2000); // Wait for 2 seconds to ensure ESCs are armed

// Run the motors at 50% speed for 45 seconds
	for (int i = 0; i < 45; i++) { // 45 seconds
		esc1.write(127); // Set ESC1 to 50% speed
		esc2.write(127); // Set ESC2 to 50% speed
		delay(1000); // Wait for 1 second
	}

// Turn off the motors
	esc1.write(0); // Send minimum signal to ESC1
	esc2.write(0); // Send minimum signal to ESC2
}

void loop(void)
{
	// The loop function is empty as all actions are handled in setup
}

/* END CODE */