Revise paste Arduino Setup rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: Arduino Setup
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-28 23:23:56

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Si la distancia del sensor es menor que 10 */
	/* entonces coloque el servo a 90° */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Ultrasonic.h>
#include <Servo.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t Ultra1_HC_SR04_Echo_PIN_D3 = 3;

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t Ultra1_HC_SR04_Trigger_PIN_D2 = 2;

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t Servo1_Servomotor_PWMSignal_PIN_D5 = 5;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Ultrasonic ultrasonic(Ultra1_HC_SR04_Trigger_PIN_D2, Ultra1_HC_SR04_Echo_PIN_D3);
Servo servo;

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(Ultra1_HC_SR04_Echo_PIN_D3, INPUT);
  pinMode(Ultra1_HC_SR04_Trigger_PIN_D2, OUTPUT);
  pinMode(Servo1_Servomotor_PWMSignal_PIN_D5, OUTPUT);
  
  servo.attach(Servo1_Servomotor_PWMSignal_PIN_D5);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  unsigned int distance = ultrasonic.read();
  
  if (distance < 10)
  {
    servo.write(90); // Set servo angle to 90 degrees
  }
  
  delay(1000);
}