Revise paste LED Control rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: LED Control
	- Source Code NOT compiled for: ESP32 DevKit V1
	- Source Code created on: 2024-08-01 12:46:49

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* if espnow protocal fails between two ESP32 module */
	/* , led should turn on */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);
void checkEspNowConnection(void); // Function to check ESP-NOW connection

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t RedlED_LED_PIN_D4 = 4; // Define the pin for the LED

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool RedlED_LED_PIN_D4_rawData = false; // Initialize raw data for LED to false

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float RedlED_LED_PIN_D4_phyData = 0.0; // Initialize physical data for LED

void setup(void)
{
    // put your setup code here, to run once:
    pinMode(RedlED_LED_PIN_D4, OUTPUT); // Set LED pin as output
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    checkEspNowConnection(); // Check the ESP-NOW connection status
    updateOutputs(); // Refresh output data
}

void updateOutputs()
{
    digitalWrite(RedlED_LED_PIN_D4, RedlED_LED_PIN_D4_rawData); // Update LED state based on raw data
}

// Function to check ESP-NOW connection
void checkEspNowConnection()
{
    // Simulating the check for ESP-NOW connection status
    bool espNowConnectionStatus = false; // Assume connection fails for demonstration

// If ESP-NOW connection fails, turn on the LED
    if (!espNowConnectionStatus) {
        RedlED_LED_PIN_D4_rawData = true; // Set raw data to true to turn on LED
    } else {
        RedlED_LED_PIN_D4_rawData = false; // Set raw data to false to turn off LED
    }
}

/* END CODE */