Revise paste LED Toggle rev_02

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: LED Toggle
	- Source Code compiled for: ESP32 DevKit V1
	- Source Code created on: 2025-02-06 10:01:42

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* The system shall control a digital LED connected */
	/* to pin D4, allowing for on/off states based on raw */
	/* data input. The LED's behavior must be updated in */
	/* real-time during the loop execution. */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t jj_LED_PIN_D4 = 4; // LED connected to pin D4

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool jj_LED_PIN_D4_rawData = false; // Initialize raw data to false (LED off)

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float jj_LED_PIN_D4_phyData = 0.0; // Placeholder for physical data transformation

void setup(void)
{
    // Initialize the LED pin as an output
    pinMode(jj_LED_PIN_D4, OUTPUT);
}

void loop(void)
{
    // Simulate raw data input for demonstration purposes
    // In a real application, this would be replaced with actual data input logic
    jj_LED_PIN_D4_rawData = !jj_LED_PIN_D4_rawData; // Toggle the raw data for testing
    updateOutputs(); // Refresh output data
    delay(1000); // Delay for 1 second to observe the LED state change
}

void updateOutputs()
{
    // Update the LED state based on the raw data
    digitalWrite(jj_LED_PIN_D4, jj_LED_PIN_D4_rawData ? HIGH : LOW);
}

/* END CODE */