Revise paste "Servo Control" rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: "Servo Control"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2024-03-20 11:46:52

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* rotate clockwise first */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Servo.h> // Include the Servo library

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
/* rotate clockwise first */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t a_Servomotor_PWMSignal_PIN_D3 = 3;
const uint8_t a_Servomotor_PWMSignal_PIN_D5 = 5;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
uint8_t a_Servomotor_PWMSignal_PIN_D3_rawData = 0;
uint8_t a_Servomotor_PWMSignal_PIN_D5_rawData = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float a_Servomotor_PWMSignal_PIN_D3_phyData = 0.0;
float a_Servomotor_PWMSignal_PIN_D5_phyData = 0.0;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Servo servo_D3; // Create an instance of the Servo class for pin D3
Servo servo_D5; // Create an instance of the Servo class for pin D5

void setup(void)
{
  // put your setup code here, to run once:

pinMode(a_Servomotor_PWMSignal_PIN_D3, OUTPUT); // Set pin D3 as output
  pinMode(a_Servomotor_PWMSignal_PIN_D5, OUTPUT); // Set pin D5 as output

servo_D3.attach(a_Servomotor_PWMSignal_PIN_D3); // Attach servo_D3 to pin D3
  servo_D5.attach(a_Servomotor_PWMSignal_PIN_D5); // Attach servo_D5 to pin D5

servo_D3.write(0); // Rotate servo_D3 clockwise to 0 degrees
  servo_D5.write(0); // Rotate servo_D5 clockwise to 0 degrees
  delay(1000); // Delay for 1 second
}

void loop(void)
{
  // put your main code here, to run repeatedly:

updateOutputs(); // Refresh output data
}

void updateOutputs()
{
  servo_D3.write(a_Servomotor_PWMSignal_PIN_D3_rawData); // Set servo_D3 position based on a_Servomotor_PWMSignal_PIN_D3_rawData
  servo_D5.write(a_Servomotor_PWMSignal_PIN_D5_rawData); // Set servo_D5 position based on a_Servomotor_PWMSignal_PIN_D5_rawData
}