Revise paste "Servo Setup" rev_01

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: "Servo Setup"
	- Source Code compiled for: Arduino Nano
	- Source Code created on: 2023-12-16 05:23:31

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Turns on and off a servo motor, ON equals GREEN */
	/* for a LED and https webserver POST and FETCH */
	/* Boolean loop */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Servo.h>
#include <ezButton.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t on_switch_Servomotor_PWMSignal_PIN_D3 = 3;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Servo myservo;
ezButton button(4); // Initialize the ezButton object with pin 4

void setup(void)
{
  // put your setup code here, to run once:

pinMode(on_switch_Servomotor_PWMSignal_PIN_D3, OUTPUT);
  
  // Attach the servo to the pin
  myservo.attach(on_switch_Servomotor_PWMSignal_PIN_D3);
  
  // Set button debounce time to 50 milliseconds
  button.setDebounceTime(50);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  
  // Read the button state
  button.loop();
  
  // If the button is pressed
  if (button.isPressed())
  {
    // Move the servo to 90 degrees
    myservo.write(90);
    delay(500);
    
    // Move the servo to 0 degrees
    myservo.write(0);
    delay(500);
  }
}