Revise paste "Sensor-Controlled Servo" rev_03

/********* Pleasedontcode.com **********

Pleasedontcode thanks you for automatic code generation! Enjoy your code!

- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

- Project: "Sensor-Controlled Servo"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2024-02-15 18:56:13

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Двигатель, подключенный к контакту D3, должен */
	/* поворачиваться ровно на 90 градусов, когда датчик */
	/* освещенности обнаруживает источник света. */
/****** END SYSTEM REQUIREMENTS *****/

/********* User code review feedback **********
#### Feedback 1 ####
- fatal error: TroykaLight.h: No such file or directory
********* User code review feedback **********/

/****** DEFINITION OF LIBRARIES *****/
#include <Servo.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t sensor_PIN_D2 = 2;

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t motor_Servomotor_PWMSignal_PIN_D3 = 3;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
uint16_t sensorValue;
float lightLuxValue;

/******** DEFINITION OF LIBRARY CLASS INSTANCES*******/
Servo myservo;

void setup(void)
{
  // put your setup code here, to run once:
  pinMode(sensor_PIN_D2, INPUT);
  myservo.attach(motor_Servomotor_PWMSignal_PIN_D3);

Serial.begin(9600);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  updateOutputs(); // Refresh output data
  delay(500); // Delay for smoother operation
}

void updateOutputs()
{
  // Read sensor input
  sensorValue = analogRead(sensor_PIN_D2);

// Map sensor value to servo angle
  int mappedVal = map(sensorValue, 0, 1023, 0, 180);

// Rotate servo to 90 degrees if light is detected
  if (sensorValue > 0) {
    mappedVal = 90;
  }

// Write mapped value to servo
  myservo.write(mappedVal);

// Print sensor and lux values
  Serial.print("Sensor value: ");
  Serial.println(sensorValue);
  Serial.print("Light Lux: ");
  Serial.println(lightLuxValue);

// Check if servo is at 90 degrees
  if (mappedVal == 90) {
    Serial.println("Servo is at 90 degrees");
  }
}