/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Button Sequence
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-09 19:13:23

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* run a rgb led with 2 buttons the buttons run 3 */
	/* colors green yellow red respectively button one */
	/* goes up the colors and stops at red button 2 goes */
	/* down the colors and stops at green */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include 
#include 

/****** FUNCTION PROTOTYPES *****/
void setup();
void loop();

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t button1_PushButton_PIN_D2 = 2;
const uint8_t button2_PushButton_PIN_D3 = 3;

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t led_LEDRGB_Red_PIN_D4 = 4;
const uint8_t led_LEDRGB_Green_PIN_D5 = 5;
const uint8_t led_LEDRGB_Blue_PIN_D6 = 6;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
EasyButton button1(button1_PushButton_PIN_D2);
EasyButton button2(button2_PushButton_PIN_D3);

bool led1On = false;
bool led2On = false;
bool led3On = false;

void setup() {
    // Set the button pins as input with pull-up resistors enabled
    pinMode(button1_PushButton_PIN_D2, INPUT_PULLUP);
    pinMode(button2_PushButton_PIN_D3, INPUT_PULLUP);

    // Set the LED pins as output
    pinMode(led_LEDRGB_Red_PIN_D4, OUTPUT);
    pinMode(led_LEDRGB_Green_PIN_D5, OUTPUT);
    pinMode(led_LEDRGB_Blue_PIN_D6, OUTPUT);
}

void loop() {
    // Read the button states
    button1.read();
    button2.read();

    // Check if button 1 is pressed
    if (button1.isPressed()) {
        if (!led3On) {
            digitalWrite(led_LEDRGB_Blue_PIN_D6, HIGH);
            led3On = true;
        } else if (!led2On) {
            digitalWrite(led_LEDRGB_Green_PIN_D5, HIGH);
            led2On = true;
        } else if (!led1On) {
            digitalWrite(led_LEDRGB_Red_PIN_D4, HIGH);
            led1On = true;
        }
    }

    // Check if button 2 is pressed
    if (button2.isPressed()) {
        if (led1On) {
            digitalWrite(led_LEDRGB_Red_PIN_D4, LOW);
            led1On = false;
        } else if (led2On) {
            digitalWrite(led_LEDRGB_Green_PIN_D5, LOW);
            led2On = false;
        } else if (led3On) {
            digitalWrite(led_LEDRGB_Blue_PIN_D6, LOW);
            led3On = false;
        }
    }
}