/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: friday
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-11-16 13:35:00
	- Source Code generated by: IRJM

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include 
#include 

/****** SYSTEM REQUIREMENT 1 *****/
	/* Turn off Led when HC05 is below 20cm */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t LED_PIN_D2 = 2;

/***** DEFINITION OF Software Serial *****/
const uint8_t HC05_mySerial_PIN_SERIAL_TX_A0 = A0;
const uint8_t HC05_mySerial_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial HC05_mySerial(HC05_mySerial_PIN_SERIAL_RX_A1, HC05_mySerial_PIN_SERIAL_TX_A0);

void setup(void)
{
	// put your setup code here, to run once:

	pinMode(LED_PIN_D2, OUTPUT);

	HC05_mySerial.begin(9600);

}


void loop(void)
{
	// put your main code here, to run repeatedly:

	// Read the distance from HC05
	int distance = HC05_mySerial.read();

	// Check if the distance is below 20cm
	if (distance < 20)
	{
		// Turn off the LED
		digitalWrite(LED_PIN_D2, LOW);
	}
	else
	{
		// Turn on the LED
		digitalWrite(LED_PIN_D2, HIGH);
	}
}