/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "Temperature Reader"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2024-03-06 07:09:39

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* turn on the led when it work */
/****** END SYSTEM REQUIREMENTS *****/


/********* User code review feedback **********
#### Feedback 1 ####
- line 26 doesn't work
********* User code review feedback **********/

/****** DEFINITION OF LIBRARIES *****/
#include 
#include 

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF I2C PINS *****/
const uint8_t but_GY_906_I2C_PIN_SDA_A4 = A4;
const uint8_t but_GY_906_I2C_PIN_SCL_A5 = A5;
const uint8_t but_GY_906_I2C_SLAVE_ADDRESS = 90;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Adafruit_MLX90614 mlx = Adafruit_MLX90614();

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
const uint8_t ledPin = 13;

void setup(void)
{
    // put your setup code here, to run once:
    pinMode(ledPin, OUTPUT);  // Set the LED pin as output

    Serial.begin(9600);
    while (!Serial);

    Serial.println("Adafruit MLX90614 test");

    Wire.begin();

    if (!mlx.begin(but_GY_906_I2C_SLAVE_ADDRESS)) {
        Serial.println("Error connecting to MLX sensor. Check wiring.");
        while (1);
    }

    Serial.print("Emissivity = "); Serial.println(mlx.readEmissivity());
    Serial.println("================================================");
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    digitalWrite(ledPin, HIGH);   // Turn on the LED

    Serial.print("Ambient = "); Serial.print(mlx.readAmbientTempC());
    Serial.print("*C\tObject = "); Serial.print(mlx.readObjectTempC()); Serial.println("*C");
    Serial.print("Ambient = "); Serial.print(mlx.readAmbientTempF());
    Serial.print("*F\tObject = "); Serial.print(mlx.readObjectTempF()); Serial.println("*F");

    digitalWrite(ledPin, LOW);   // Turn off the LED

    Serial.println();
    delay(500);
}