/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Bluetooth Counter
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-10 05:01:53

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* compare the number of ble peripherals with rssi */
	/* value above -40 with buetooth peripherals below */
	/* -40. do not detect blutooth peripherals with rssi */
	/* value above -60 */
/****** SYSTEM REQUIREMENT 2 *****/
	/* compare the number of ble peripherals with rssi */
	/* value above -40 with buetooth peripherals below */
	/* -40. if a is more send 9 volts to pin 13. if b is */
	/* more 9 volts to pin 11 .send do not detect */
	/* blutooth peripherals with rssi value above -60 */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <SoftwareSerial.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF Software Serial *****/
const uint8_t d_HC05_mySerial_PIN_SERIAL_TX_A0 = A0; // Define the pin for TX
const uint8_t d_HC05_mySerial_PIN_SERIAL_RX_A1 = A1; // Define the pin for RX
SoftwareSerial d_HC05_mySerial(d_HC05_mySerial_PIN_SERIAL_RX_A1, d_HC05_mySerial_PIN_SERIAL_TX_A0);

void setup(void)
{
  // put your setup code here, to run once:

  d_HC05_mySerial.begin(9600);
  pinMode(13, OUTPUT); // Set pin 13 as output
  pinMode(11, OUTPUT); // Set pin 11 as output
}

void loop(void)
{
  // put your main code here, to run repeatedly:

  int bleCount = 0; // Counter for BLE peripherals
  int rssi = -50; // Sample RSSI value

  // Check if BLE peripherals have RSSI above -40
  if (rssi > -40) {
    bleCount++;
  }

  // Check if Bluetooth peripherals have RSSI below -40
  if (rssi < -40) {
    bleCount--;
  }

  // Compare the number of BLE peripherals with RSSI value above -40
  if (bleCount > 0) {
    digitalWrite(13, HIGH); // Send 9 volts to pin 13
  } else if (bleCount < 0) {
    digitalWrite(11, HIGH); // Send 9 volts to pin 11
  }

  delay(1000); // Delay for 1 second
}

/* END CODE */