/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Button Control
	- Source Code compiled for: Arduino Nano
	- Source Code created on: 2024-01-11 22:28:59

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* spradzaj do nieskończoność czas trwania podania */
	/* napiecia do pin 8. Jeśli czas trwania napiecia do */
	/* pin 8 jest równy 3000 ms podaj napiecie do pin 8 */
	/* do czas trwania 10000 ms i zakoncz podanie */
	/* napiecia do pin 8. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <EasyButton.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void checkButton(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t Button1_PushButton_PIN_D2 = 2;
const uint8_t VoltageOutput_PIN_D8 = 8;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
EasyButton button(Button1_PushButton_PIN_D2);

// Flag to track if the voltage has been applied to pin 8
bool voltageApplied = false;

// Time at which the voltage was applied to pin 8
unsigned long voltageStartTime;

void setup(void)
{
  // Initialize the button
  button.begin();

  // Set the button callback function
  button.onPressedFor(3000, checkButton);

  // Set the voltage output pin as an output
  pinMode(VoltageOutput_PIN_D8, OUTPUT);

  // Initialize the voltage output pin to LOW
  digitalWrite(VoltageOutput_PIN_D8, LOW);
}

void loop(void)
{
  // Continuously read the button state
  button.read();

  // Check if the voltage has been applied to pin 8
  if (voltageApplied)
  {
    unsigned long currentTime = millis();
    unsigned long duration = currentTime - voltageStartTime;

    // Check if the duration is equal to 3000 ms
    if (duration == 3000)
    {
      // Apply voltage to pin 8 for a duration of 10000 ms
      digitalWrite(VoltageOutput_PIN_D8, HIGH);
      delay(10000);
      digitalWrite(VoltageOutput_PIN_D8, LOW);

      // Reset the flag and start time
      voltageApplied = false;
      voltageStartTime = 0;
    }
  }
}

// Callback function called when the button is pressed for the specified duration
void checkButton()
{
  // Set the flag and record the start time
  voltageApplied = true;
  voltageStartTime = millis();
}