/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "Blynk Relay"
	- Source Code NOT compiled for: Arduino Uno
	- Source Code created on: 2024-06-29 17:42:07

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* The system should control a relay module connected */
	/* to digital pin D2 using the Relay library. The */
	/* relay on off same as switch on off at blynk */
/****** SYSTEM REQUIREMENT 2 *****/
	/* Create a system to manage a relay module on */
	/* digital pin D2 with the Relay library. The relay */
	/* should respond to a Blynk app switch, ensuring */
	/* synchronized on/off states for efficient remote */
	/* control. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include   //https://github.com/rafaelnsantos/Relay
#include   // Blynk library for serial communication

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);
BLYNK_WRITE(V1); // Blynk function to handle virtual pin V1 writes

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t relay_RelayModule_Signal_PIN_D2 = 2;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool relay_RelayModule_Signal_PIN_D2_rawData = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float relay_RelayModule_Signal_PIN_D2_phyData = 0.0;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Relay light(relay_RelayModule_Signal_PIN_D2, true); // Initialize relay on pin 2, Normally Open

/****** BLYNK AUTH TOKEN *****/
char auth[] = "YourAuthToken"; // Replace with your Blynk Auth Token

void setup(void)
{
    // put your setup code here, to run once:
    Serial.begin(9600); // Initialize serial communication
    Blynk.begin(Serial, auth); // Initialize Blynk with serial communication
    light.begin(); // Initialize the pin
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    Blynk.run(); // Run Blynk
    updateOutputs(); // Refresh output data
}

void updateOutputs()
{
    // Example of using the Relay library functions
    relay_RelayModule_Signal_PIN_D2_rawData = light.getState(); // Get relay state
}

// Blynk function to handle virtual pin V1 writes
BLYNK_WRITE(V1)
{
    int pinValue = param.asInt(); // Get the value from the Blynk app
    if (pinValue == 1) {
        light.turnOn(); // Turn relay on
    } else {
        light.turnOff(); // Turn relay off
    }
}