/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: LED Control
	- Source Code NOT compiled for: ESP32 DevKit V1
	- Source Code created on: 2025-11-15 10:02:29

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Utilize the ESP32 DevKit V1's GPIO pins to control */
	/* an onboard LED and read input from a connected */
	/* push button, enabling basic user interaction. */
/****** END SYSTEM REQUIREMENTS *****/


/* START CODE */

// Include the Arduino core library
#include 

// Define GPIO pins for onboard LED and push button
const int onboardLedPin = 2; // Onboard LED pin for ESP32 DevKit V1
const int pushButtonPin = 0; // Connected push button pin (change if different)

// Variable to store button state
int buttonState = 0;

void setup() {
  // Initialize serial communication at 115200 baud rate
  Serial.begin(115200);

  // Initialize the onboard LED pin as output
  pinMode(onboardLedPin, OUTPUT);
  // Initialize the push button pin as input with internal pull-up resistor
  pinMode(pushButtonPin, INPUT_PULLUP);
}

void loop() {
  // Read the state of the push button
  buttonState = digitalRead(pushButtonPin);
  // Check if button is pressed (active low)
  if (buttonState == LOW) {
    // Turn on the onboard LED
    digitalWrite(onboardLedPin, HIGH);
  } else {
    // Turn off the onboard LED
    digitalWrite(onboardLedPin, LOW);
  }
  // Small delay for debounce and stability
  delay(10);
}

/* END CODE */