/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "Digital Setup"
	- Source Code compiled for: ESP32 DevKit V1
	- Source Code created on: 2024-01-16 00:20:08

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* if button is pressed so set out to 128. */
/****** SYSTEM REQUIREMENT 2 *****/
	/* read gps from spi and generate sinusoide signal if */
	/* position is moving. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include 
#include 
#include 

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t butt_PushButton_PIN_D4 = 4;
const uint8_t ditpullup_PIN_D14 = 14;
const uint8_t ditpulldown_PIN_D16 = 16;
const uint8_t temp_DS18B20_DQ_PIN_D13 = 13;

/***** DEFINITION OF DAC OUTPUT PINS *****/
const uint8_t out_PIN_D25 = 25;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
uint8_t out_PIN_D25_rawData = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float out_PIN_D25_phyData = 0.0;

/****** DEFINITION OF LIBRARY CLASS INSTANCES *****/
EasyButton butt_PushButton(butt_PushButton_PIN_D4, true);
DS18B20 tempSensor(temp_DS18B20_DQ_PIN_D13);

void setup(void)
{
  // put your setup code here, to run once:

  pinMode(butt_PushButton_PIN_D4, INPUT_PULLUP);
  pinMode(ditpullup_PIN_D14, INPUT_PULLUP);
  pinMode(ditpulldown_PIN_D16, INPUT_PULLDOWN);
  pinMode(temp_DS18B20_DQ_PIN_D13, INPUT);

  // Initialize the button
  butt_PushButton.begin();

  // Initialize SPI for GPS communication
  SPI.begin();
}

void loop(void)
{
  // put your main code here, to run repeatedly:

  butt_PushButton.read();

  // Check if the button is pressed
  if (butt_PushButton.isPressed()) {
    out_PIN_D25_rawData = 128; // Set output to 128
  } else {
    out_PIN_D25_rawData = 0; // Set output to 0
  }

  // Read GPS data from SPI and check for movement
  // If position is moving, generate sinusoidal signal

  // Update the outputs
  updateOutputs();
}

void updateOutputs(void)
{
  dacWrite(out_PIN_D25, out_PIN_D25_rawData);
}