/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "LED Control"
	- Source Code NOT compiled for: Arduino Uno
	- Source Code created on: 2024-11-19 14:24:49

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* if typed 1 in terminal then led turns on and if */
	/* typed 0 it goes off */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include 

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void); // Added function prototype for updateOutputs

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t dede_LED_PIN_D2 = 2;
const int ledPin = 13; // Added USER CODE for another LED pin

/***** DEFINITION OF Software Serial *****/
const uint8_t blueblue_HC05_mySerial_PIN_SERIAL_TX_A0 = A0;
const uint8_t blueblue_HC05_mySerial_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial blueblue_HC05_mySerial(blueblue_HC05_mySerial_PIN_SERIAL_RX_A1, blueblue_HC05_mySerial_PIN_SERIAL_TX_A0);

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool dede_LED_PIN_D2_rawData = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float dede_LED_PIN_D2_phyData = 0.0;

void setup(void)
{
    // put your setup code here, to run once:
    pinMode(dede_LED_PIN_D2, OUTPUT);
    pinMode(ledPin, OUTPUT); // Set up the additional LED pin

    blueblue_HC05_mySerial.begin(9600);
    Serial.begin(9600); // Set baud rate to 9600 for Serial communication (added from USER CODE)
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    updateOutputs(); // Refresh output data

    if (Serial.available() > 0) { // Added from USER CODE
        char data = Serial.read(); // Read data from Serial
        if (data == '1') {
            digitalWrite(ledPin, HIGH); // Turn additional LED on
        } else if (data == '0') {
            digitalWrite(ledPin, LOW); // Turn additional LED off
        }
    }
}

void updateOutputs()
{
    digitalWrite(dede_LED_PIN_D2, dede_LED_PIN_D2_rawData);
}

/* END CODE */