/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "CAN Communication"
	- Source Code NOT compiled for: ESP32 DevKit V1
	- Source Code created on: 2024-11-27 20:49:33

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Receive message from ArduPilot through CAN bus */
	/* using DroneCan protocol */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include           // Include SPI library for communication
#include      // Include MCP2515 library for CAN interface
#include      // Include DroneCAN library for DroneCAN protocol

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

// Create an instance of the MCP2515 CAN controller
MCP2515 mcp2515(10); // Assuming CS pin is 10

// Create an instance of the DroneCAN protocol
DroneCAN droneCAN(mcp2515);

void setup(void)
{
    // Initialize the CAN bus
    mcp2515.reset();
    mcp2515.setBitrate(CAN_500KBPS, MCP2515_16MHZ); // Set bitrate to 500 kbps
    mcp2515.setNormalMode(); // Set CAN to normal mode

    // Initialize DroneCAN
    droneCAN.begin();
}

void loop(void)
{
    // Check for incoming messages
    if (droneCAN.available()) {
        // Read the incoming message
        can_frame frame;
        droneCAN.read(frame);

        // Process the received message
        // (Add your message processing logic here)
    }

    // Other loop code can go here
}

/* END CODE */