/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Scanner
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-10-29 13:53:19
	- Source Code generated by: AlexWind

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <EasyButton.h>

/****** SYSTEM REQUIREMENT 1 *****/
/* If sensor detects dryness in soil, water motor starts.
   If sensor detects wetness in soil, water motor stops. */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t Soilmoisturesensor_PushButton_PIN_D2 = 2;
const uint8_t Soilmoisturesensor_PushButton_PIN_D3 = 3;

// Create EasyButton objects for the soil moisture sensor push buttons
EasyButton drynessButton(Soilmoisturesensor_PushButton_PIN_D2);
EasyButton wetnessButton(Soilmoisturesensor_PushButton_PIN_D3);

// Define water motor control pin
const uint8_t WaterMotor_PIN = 4;

void setup(void)
{
  // Set the input mode for the pins connected to the soil moisture sensor push buttons
  pinMode(Soilmoisturesensor_PushButton_PIN_D2, INPUT_PULLUP);
  pinMode(Soilmoisturesensor_PushButton_PIN_D3, INPUT_PULLUP);

  // Set the output mode for the water motor control pin
  pinMode(WaterMotor_PIN, OUTPUT);

  // Initialize the EasyButton objects
  drynessButton.begin();
  wetnessButton.begin();

  // Add your setup code here, to run once:
}

void loop(void)
{
  // Read the state of the soil moisture sensor push buttons
  drynessButton.read();
  wetnessButton.read();

  // Check if the dryness button is pressed
  if (drynessButton.isPressed()) {
    // Start the water motor
    digitalWrite(WaterMotor_PIN, HIGH);
  }

  // Check if the wetness button is pressed
  if (wetnessButton.isPressed()) {
    // Stop the water motor
    digitalWrite(WaterMotor_PIN, LOW);
  }

  // Add your main code here, to run repeatedly:
}