/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: LED Control
	- Source Code NOT compiled for: ESP32 DevKit V1
	- Source Code created on: 2024-05-03 11:37:32

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* PWM CONTOLL */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void); // Added function prototype for updateOutputs

/***** DEFINITION OF ANALOG INPUT PINS *****/
const uint8_t pot_Potentiometer_Vout_PIN_D4 = D4;

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t isik_LED_PIN_D13 = 13;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool isik_LED_PIN_D13_rawData = 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float isik_LED_PIN_D13_phyData = 0.0;

void setup(void)
{
    // put your setup code here, to run once:
    pinMode(pot_Potentiometer_Vout_PIN_D4, INPUT);
    pinMode(isik_LED_PIN_D13, OUTPUT);

    // PWM CONTROL
    // Set PWM frequency for LED control
    ledcSetup(0, 5000, 8); // Configure PWM channel at 5 kHz with 8-bit resolution
    ledcAttachPin(isik_LED_PIN_D13, 0); // Attach PWM channel to LED pin
}

void loop(void)
{
    // put your main code here, to run repeatedly:
    updateOutputs(); // Refresh output data
}

void updateOutputs()
{
    // Update LED brightness using PWM
    ledcWrite(0, isik_LED_PIN_D13_rawData); // Set PWM duty cycle based on raw data
}

/* END CODE */