/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: LED Control
	- Source Code NOT compiled for: ESP32 DevKit V1
	- Source Code created on: 2024-08-01 12:58:00

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* if espnow protocal fails between two ESP32 module */
	/* , led should turn on */
/****** SYSTEM REQUIREMENT 2 *****/
	/* turn on the led if input get high */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
void updateOutputs(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t RedlED_LED_PIN_D4 = 4; // Define the pin for the LED

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
bool RedlED_LED_PIN_D4_rawData = false; // Initialize raw data for the LED

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float RedlED_LED_PIN_D4_phyData = 0.0; // Initialize physical data for the LED

// Define a variable to simulate the ESP-NOW protocol status
bool espNowProtocolStatus = true; // Assume the protocol is working initially

void setup(void)
{
    // Initialize the LED pin as an output
    pinMode(RedlED_LED_PIN_D4, OUTPUT);
    pinMode(2, INPUT); // Initialize pin 2 as an input for monitoring
}

void loop(void)
{
    // Check the status of the ESP-NOW protocol
    if (!espNowProtocolStatus) {
        // If the ESP-NOW protocol fails, turn on the LED
        RedlED_LED_PIN_D4_rawData = true; // Set raw data to true to turn on the LED
    } else {
        // Check for a high input signal
        int inputSignal = digitalRead(2); // Read from pin 2
        if (inputSignal == HIGH) {
            RedlED_LED_PIN_D4_rawData = true; // Turn on the LED if input is high
        } else {
            RedlED_LED_PIN_D4_rawData = false; // Turn off the LED if input is low
        }
    }

    updateOutputs(); // Refresh output data
}

void updateOutputs()
{
    // Write the current state of raw data to the LED pin
    digitalWrite(RedlED_LED_PIN_D4, RedlED_LED_PIN_D4_rawData);
}

/* END CODE */