/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: **Communication Protocols**
	- Source Code NOT compiled for: Arduino Mega
	- Source Code created on: 2024-11-04 14:07:30

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* print one time output. */
/****** END SYSTEM REQUIREMENTS *****/

/* START CODE */

/****** DEFINITION OF LIBRARIES *****/
#include 
#include 
#include 

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t out_PIN_D3		= 3;

/***** DEFINITION OF Hardware Serial *****/
#define uarthw	Serial1	// TX_PIN: D18, RX_PIN: D19

/***** DEFINITION OF Software Serial *****/
const uint8_t uartsw_PIN_SERIAL_TX_D4		= 4;
const uint8_t uartsw_PIN_SERIAL_RX_A0		= A0;
SoftwareSerial uartsw(uartsw_PIN_SERIAL_RX_A0, uartsw_PIN_SERIAL_TX_D4);

/***** DEFINITION OF I2C PINS *****/
const uint8_t i2c_PIN_SDA_D20		= 20;
const uint8_t i2c_PIN_SCL_D21		= 21;

/***** DEFINITION OF SPI PINS *****/
const uint8_t spi_PIN_MOSI_D51		= 51;
const uint8_t spi_PIN_MISO_D50		= 50;
const uint8_t spi_PIN_SCLK_D52		= 52;
const uint8_t spi_PIN_CS_D53		= 53;

/***** DEFINITION OF OUTPUT RAW VARIABLES *****/
/***** used to store raw data *****/
uint8_t	out_PIN_D3_rawData		= 0;

/***** DEFINITION OF OUTPUT PHYSICAL VARIABLES *****/
/***** used to store data after characteristic curve transformation *****/
float	out_PIN_D3_phyData		= 0.0;

void setup(void)
{
	// put your setup code here, to run once:

	pinMode(out_PIN_D3,	 OUTPUT);

	pinMode(spi_PIN_CS_D53,	 OUTPUT);
	// start the SPI library:
	SPI.begin();

	uarthw.begin(300);

	uartsw.begin(300);

	// Print one-time output
	Serial.begin(9600); // Initialize Serial for output
	Serial.println("Setup complete. System is running."); // One-time output
}

void loop(void)
{
	// put your main code here, to run repeatedly:

	updateOutputs(); // Refresh output data

}

void updateOutputs()
{
	analogWrite(out_PIN_D3, out_PIN_D3_rawData);
}

/* END CODE */