/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: LED Controller
	- Source Code NOT compiled for: Arduino Mega
	- Source Code created on: 2025-11-15 18:03:49

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* if b13 = low and b12 = low , l11 = HIGH  if b13 = */
	/* low and b12 = HIGH , l11 = HIGH  if b13 = HIGH and */
	/* b12 = low , l11 = HIGH  if b13 = HIGH and b12 = */
	/* HIGH , l11 =low */
/****** END SYSTEM REQUIREMENTS *****/


/* START CODE */

// System Requirements:
// This program reads the states of two push buttons connected to pins 13 and 12.
// Controls an LED connected to pin 11 based on the button presses.
// The LED turns ON or OFF depending on the combination of button states.

void setup() {
  // Initialize push buttons as input with internal pull-up resistors
  pinMode(13, INPUT_PULLUP); // Push Button 1
  pinMode(12, INPUT_PULLUP); // Push Button 2
  // Initialize LED pin as output
  pinMode(11, OUTPUT); // LED
}

void loop() {
  // Read the state of the push buttons
  bool button1 = digitalRead(13); // Button 1 state
  bool button2 = digitalRead(12); // Button 2 state

  // Determine LED state based on button states
  // According to system requirements:
  // "if b13 = low and b12 = low, l11 = HIGH"
  // "if b13 = low and b12 = HIGH, l11 = HIGH"
  // "if b13 = HIGH and b12 = low, l11 = HIGH"
  // "if b13 = HIGH and b12 = HIGH, l11 = LOW"

  if ((button1 == LOW && button2 == LOW) ||
      (button1 == LOW && button2 == HIGH) ||
      (button1 == HIGH && button2 == LOW)) {
    digitalWrite(11, HIGH); // Turn ON LED
  } else {
    digitalWrite(11, LOW); // Turn OFF LED
  }
}

/* END CODE */