/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "Servo Control"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-16 17:05:56

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Servo motor ups and down when the sensor detected */
	/* anything at the front of sensor. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <Servo.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t Ultrasonicsensor_Servomotor_PWMSignal_PIN_D3 = 3;
const uint8_t Ultrasonicsensor_Servomotor_PWMSignal_PIN_D5 = 5;

/****** DEFINITION OF LIBRARIES CLASS INSTANCES*****/
Servo servo1;
Servo servo2;

void setup(void)
{
  // Attach the servo motors to the PWM output pins
  servo1.attach(Ultrasonicsensor_Servomotor_PWMSignal_PIN_D3);
  servo2.attach(Ultrasonicsensor_Servomotor_PWMSignal_PIN_D5);
}

void loop(void)
{
  // put your main code here, to run repeatedly:
  
  // Check if the sensor detects anything at the front
  // of the sensor
  // Add your code here to check the sensor input
  
  // If the sensor detects something, move the servo motors
  // up and down
  // Add your code here to control the servo motors based on
  // the sensor input
  
}