/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Servo Control
	- Source Code NOT compiled for: Arduino Nano
	- Source Code created on: 2024-10-19 12:44:26

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* start servos with throttles minimum for 10s, then */
	/* start at 25% power for 45s and after that turn off */
	/* servos */
/****** SYSTEM REQUIREMENT 2 *****/
	/* two escs connected to specify pins, start with */
	/* arming motors and wait 15s with throttles in */
	/* minimum positions, then start motors with 25% */
	/* speed for 45s a then turn off the motors */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include 	// https://github.com/arduino-libraries/Servo
#include 	// https://github.com/RB-ENantel/RC_ESC

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF PWM OUTPUT PINS *****/
const uint8_t motor_Servomotor_PWMSignal_PIN_D3		= 3; // Pin for first servo
const uint8_t motor2_Servomotor_PWMSignal_PIN_D5		= 5; // Pin for second servo

/****** DEFINITION OF LIBRARIES CLASS INSTANCES *****/
Servo myServo1; // Instance of Servo class for motor on pin D3
Servo myServo2; // Instance of Servo class for motor on pin D5
ESC myESC1(9, 1000, 2000, 500); // Instance of ESC class for first ESC
ESC myESC2(10, 1000, 2000, 500); // Instance of ESC class for second ESC

void setup(void)
{
	// Set the PWM pins as outputs
	pinMode(motor_Servomotor_PWMSignal_PIN_D3, OUTPUT);
	pinMode(motor2_Servomotor_PWMSignal_PIN_D5, OUTPUT);

	// Attach the servos to their respective pins
	myServo1.attach(motor_Servomotor_PWMSignal_PIN_D3);
	myServo2.attach(motor2_Servomotor_PWMSignal_PIN_D5);

	// Start ESC calibration for both ESCs
	myESC1.calib();
	myESC2.calib();

	// Wait for 15 seconds with minimum throttle for ESCs
	delay(15000);

	// Start motors at 25% power for 45 seconds
	myESC1.write(64); // 25% throttle for first ESC
	myESC2.write(64); // 25% throttle for second ESC
	delay(45000); // Run at 25% power for 45 seconds

	// Stop the motors
	myESC1.stop();
	myESC2.stop();
}

void loop(void)
{
	// Main loop does not need to perform any actions
}