/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: "BLE Scanner"
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-09 19:07:38

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* scan for ble peripherals and their uuid . If rssi */
	/* value more than -40 add the number of */
	/* uuid's(=variable a) and compare it with the number */
	/* of uuid's with rssi value less than -40(=variable */
	/* b). */
/****** SYSTEM REQUIREMENT 2 *****/
	/* make two variables. a is the number of  ble */
	/* peripherals whose rssi is above -40 . b is the */
	/* number of ble peripherals whose rssi value is */
	/* below -40 . */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <SoftwareSerial.h>

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);
int readRSSI(void);

/****** SYSTEM REQUIREMENTS *****/
// SYSTEM REQUIREMENT 1:
// scan for BLE peripherals and their UUIDs. If the rssi
// value is more than -40, increment the number of
// UUIDs (variable a) and compare it with the number
// of UUIDs with an rssi value less than -40 (variable
// b).

// SYSTEM REQUIREMENT 2:
// declare two variables: a for the number of BLE
// peripherals whose rssi is above -40, and b for the
// number of BLE peripherals whose rssi value is
// below -40.
/****** END SYSTEM REQUIREMENTS *****/

/***** DEFINITION OF Software Serial *****/
const uint8_t d_HC05_mySerial_PIN_SERIAL_TX_A0 = A0;
const uint8_t d_HC05_mySerial_PIN_SERIAL_RX_A1 = A1;
SoftwareSerial d_HC05_mySerial(d_HC05_mySerial_PIN_SERIAL_RX_A1, d_HC05_mySerial_PIN_SERIAL_TX_A0);

// Variables for the system requirements
int a = 0;
int b = 0;

void setup(void) {
  // put your setup code here, to run once:
  d_HC05_mySerial.begin(9600);
}

void loop(void) {
  // put your main code here, to run repeatedly:

  // Update the values of a and b based on the system requirements

  // Read the RSSI value of BLE peripherals
  int rssi = readRSSI();

  // Check if the RSSI value is above -40
  if (rssi > -40) {
    a++;
  } else {
    b++;
  }

  // Compare the values of a and b
  if (a > b) {
    // Do something
  } else {
    // Do something else
  }
}

int readRSSI(void) {
  // Code to read the RSSI value from BLE peripheral
  // You need to implement this code based on the hardware you are using
  // Return the read RSSI value
  return 0;
}