/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: GPSSTARTER
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-11-12 04:05:33
	- Source Code generated by: Mahendra

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include <Arduino.h>
#include <SIM800L-SOLDERED.h>

/****** SYSTEM REQUIREMENT 1 *****/
/* When power on Read after 3 second VINPUT VALUE */
/* if  READ VVALUE=2.5v+-10%  Led on and print PUMP */
/* ON  Delay 3second  Read AVALUE=2V+-10%  IF READ */
/* OVER RANGE  LED OFF AND PRINT PUMP OFF      PRINT */
/* IN DISPLAY AND MASSEGE IN */
/****** SYSTEM REQUIREMENT 2 *****/
/* Read massage work and replay ON MOBILE NO  Read */
/* massage =1  Send AINPUT ,VINPUT,PUMP ON/PUMP OFF */
/* READ MASSAGE =2  OUTPUT LED ON  REPLAY PUMP ON */
/* READ MASSAGE =3  OUTPUT LED OFF REPLAY PUMP OFF */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF ANALOG INPUT PINS *****/
const uint8_t VINPUT_PIN_A0 = A0;
const uint8_t AINPUT_PIN_A1 = A1;

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t Output_LED_PIN_D2 = 2;

/***** DEFINITION OF Hardware Serial *****/
SIM800L sim800(8, 9);

void setup(void)
{
  // put your setup code here, to run once:

  pinMode(VINPUT_PIN_A0, INPUT);
  pinMode(AINPUT_PIN_A1, INPUT);

  pinMode(Output_LED_PIN_D2, OUTPUT);

  sim800.begin();
}

void loop(void)
{
  // put your main code here, to run repeatedly:
}