/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Scanner
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-10-29 15:10:29
	- Source Code generated by: AlexWind

********* Pleasedontcode.com **********/
/****** DEFINITION OF LIBRARIES *****/
#include 
#include 
#include 
#include 

/****** SYSTEM REQUIREMENT 1 *****/
/* Reads NMEA 8bit data from GPS module. Reads hours */
/* minutes, seconds and Display h, m, s on LED */
/* display. When mins and secs are 00 00, contact */
/* closure for about 1 sec. */

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL OUTPUT PINS *****/
const uint8_t contactClosure_PIN_D2 = 2;

/***** DEFINITION OF Software Serial *****/
const uint8_t gpsSerial_PIN_SERIAL_TX_A1 = A1;
const uint8_t gpsSerial_PIN_SERIAL_RX_A0 = A0;
SoftwareSerial gpsSerial(gpsSerial_PIN_SERIAL_RX_A0, gpsSerial_PIN_SERIAL_TX_A1);

void setup(void)
{
  // Set the contact closure pin as output
  pinMode(contactClosure_PIN_D2, OUTPUT);

  // Initialize the GPS serial communication
  gpsSerial.begin(9600);

  // Initialize other setup code here
}

void loop(void)
{
  // Read NMEA data from the GPS module
  while (gpsSerial.available())
  {
    char c = gpsSerial.read();
    // Process the NMEA data here
    // Extract hours, minutes, and seconds from the NMEA data
    // Display the values on the LED display

    // Declare and initialize minutes and seconds variables
    int minutes = 0;
    int seconds = 0;

    // Check if minutes and seconds are both 00
    if (minutes == 0 && seconds == 0)
    {
      // Make a contact closure for about 1 second
      digitalWrite(contactClosure_PIN_D2, HIGH);
      delay(1000);
      digitalWrite(contactClosure_PIN_D2, LOW);
    }
  }
}