/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Button Interrupt
	- Source Code compiled for: Arduino Uno
	- Source Code created on: 2023-12-28 00:52:14

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* 4 floor lift, when call button press from any */
	/* floor lift reaches there and floor sensor detects */
	/* lift car the motor will off. when call button */
	/* pressed from another floor lift starts move until */
	/* floor sensor detects lift car on that floor */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include 
#include 

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF DIGITAL INPUT PINS *****/
const uint8_t Callbutton_PushButton_PIN_D2 = 2;

/****** DEFINITION OF LIBRARY CLASS INSTANCES*****/
EasyButton button(Callbutton_PushButton_PIN_D2);  // Instance of the EasyButton class

/****** FUNCTION PROTOTYPES *****/
void motorOff();
void moveToFloor(int floor);

void setup(void)
{
  // Initialize Serial for debugging purposes.
  Serial.begin(115200);

  Serial.println();
  Serial.println(">>> EasyButton interrupts example <<<");

  // Initialize the button.
  button.begin();

  // Define button callback functions
  button.onPressed([]() {
    motorOff();
  });

  button.onSequence(2, 1500, []() {
    button.disableInterrupt(); // Disable interrupt during movement
    moveToFloor(2);
    delay(1000); // Wait for the floor sensor to detect the lift car
    button.enableInterrupt([]() {}); // Re-enable interrupt after movement is complete
  });

  // Enable interrupt if supported by the board
  if (button.supportsInterrupt())
  {
    button.enableInterrupt([]() {});
    Serial.println("Button will be used through interrupts");
  }
}

void loop(void)
{
  // put your main code here, to run repeatedly:

  button.read();  // Read button state and trigger callbacks if necessary
}

void motorOff()
{
  // Code to turn off the motor
  Serial.println("Motor off");
}

void moveToFloor(int floor)
{
  // Code to move the lift to the desired floor
  Serial.print("Moving to floor ");
  Serial.println(floor);
}