/********* Pleasedontcode.com **********

	Pleasedontcode thanks you for automatic code generation! Enjoy your code!

	- Terms and Conditions:
	You have a non-exclusive, revocable, worldwide, royalty-free license
	for personal and commercial use. Attribution is optional; modifications
	are allowed, but you're responsible for code maintenance. We're not
	liable for any loss or damage. For full terms,
	please visit pleasedontcode.com/termsandconditions.

	- Project: Bluetooth Communication
	- Source Code NOT compiled for: Arduino Nano ESP32
	- Source Code created on: 2024-08-18 07:23:03

********* Pleasedontcode.com **********/

/****** SYSTEM REQUIREMENTS *****/
/****** SYSTEM REQUIREMENT 1 *****/
	/* Develop a setup function to initialize the HC-05 */
	/* Bluetooth module for reliable data transmission */
	/* and a loop function for continuous operation in an */
	/* Arduino environment. */
/****** END SYSTEM REQUIREMENTS *****/

/****** DEFINITION OF LIBRARIES *****/
#include  //https://github.com/plerup/espsoftwareserial

/****** FUNCTION PROTOTYPES *****/
void setup(void);
void loop(void);

/***** DEFINITION OF Software Serial *****/
const uint8_t dd_HC05_mySerial_PIN_SERIAL_TX_A0 = A0; // Define TX pin for HC-05
const uint8_t dd_HC05_mySerial_PIN_SERIAL_RX_A1 = A1; // Define RX pin for HC-05
EspSoftwareSerial::UART dd_HC05_mySerial; // Create an instance of SoftwareSerial

void setup(void)
{
	// Initialize the serial communication for HC-05 Bluetooth module
	dd_HC05_mySerial.begin(9600, SWSERIAL_8N1, dd_HC05_mySerial_PIN_SERIAL_RX_A1, dd_HC05_mySerial_PIN_SERIAL_TX_A0, false);
	
	// Optional: Start the Serial Monitor for debugging
	Serial.begin(9600); // Start the hardware serial for debugging
	Serial.println("HC-05 Bluetooth Module Initialized");
}

void loop(void)
{
	// Continuously check if data is available from the HC-05
	if (dd_HC05_mySerial.available()) {
		char receivedChar = dd_HC05_mySerial.read(); // Read the incoming data
		Serial.print("Received: "); // Print received data to Serial Monitor
		Serial.println(receivedChar);
	}

	// Optional: Send a test message to the HC-05
	// Uncomment the following lines to send data periodically
	/*
	dd_HC05_mySerial.println("Hello from Arduino!"); // Send a test message
	delay(1000); // Wait for 1 second before sending again
	*/
}

/* END CODE */